HDD 2.5" 1TB Seagate FireCuda

\u043e\u0442\u043b\u0438\u0447\u043d\u044b\u0439 \u0434\u0438\u0441\u043a, \u043c\u043e\u0433\u0443 \u043e\u0442\u043f\u0440\u0430\u0432\u0438\u0442\u044c \u0434\u043e\u0441\u0442\u0430\u0432\u043a\u043e\u0439 smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.7.9-100.fc38.x86_64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke === START OF INFORMATION SECTION === Model Family: Seagate FireCuda 2.5 Device Model: ST1000LX015-1U7172 Serial Number: WDEHFM0X LU WWN Device Id: 5 000c50 0aaf38236 Firmware Version: SDM2 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5528 ATA Version is: ACS-3 T13/2161-D revision 3b SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Apr 3 08:34:12 2024 +05 SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x71) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 168) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 083 064 006 Pre-fail Always - 180617759 3 Spin_Up_Time 0x0003 099 099 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 071 071 020 Old_age Always - 30455 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 081 060 045 Pre-fail Always - 135435162 9 Power_On_Hours 0x0032 092 092 000 Old_age Always - 7322 (190 166 0) 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 098 098 020 Old_age Always - 2968 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0 188 Command_Timeout 0x0032 100 099 000 Old_age Always - 28 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 073 051 040 Old_age Always - 27 (Min/Max 24/27) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 42 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 54 193 Load_Cycle_Count 0x0032 079 079 000 Old_age Always - 42601 194 Temperature_Celsius 0x0022 027 049 000 Old_age Always - 27 (255 248 0 0 0) 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 11091h+40m+27.250s 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 27545050667 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 41775635570 254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 6672 - # 2 Short offline Completed without error 00% 6672 - # 3 Short offline Aborted by host 30% 6672 - # 4 Short offline Completed without error 00% 1840 - # 5 Short offline Completed without error 00% 1593 - # 6 Short offline Completed without error 00% 1525 - # 7 Short offline Completed without error 00% 1435 - # 8 Short offline Completed without error 00% 1357 - # 9 Short offline Completed without error 00% 1270 - #10 Short offline Completed without error 00% 1183 - #11 Short offline Completed without error 00% 1180 - #12 Short offline Aborted by host 90% 1179 - #13 Short offline Aborted by host 90% 1179 - #14 Short offline Aborted by host 90% 1179 - #15 Short offline Completed without error 00% 1179 - #16 Short offline Aborted by host 90% 1179 - #17 Short offline Aborted by host 80% 1179 - #18 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. The above only provides legacy SMART information - try 'smartctl -x' for more